Building a Fence Gate: 6 Steps (with Pictures)

How to install wood fence gate?

Install / July 13, 2019

Video Playback Not Supported

How to Build a Wooden Fence

This is the sixth of a seven-part series on building a wood picket fence:

There are several ways to reinforce a fence gate to keep it from sagging. A section of preassembled fencing can be used as a gate as long as extra reinforcement is used. Here’s how to go about it:

  1. Cut the panel to the correct size for the gate opening.
  2. Rip 2” thick pressure treated lumber to the width of the existing rails (stringers) on the gate.
  3. Lay the gate on a flat surface, and square it up.
  4. Measure the distance between the top and bottom rails.
  5. Cut the boards to length so they are a tight fit between the rails on each end of the gate.
  6. Secure the two vertical framing boards even with each end of gate using corrosion resistant screws.
  7. Measure and cut a diagonal support board to fit snuggly inside the opposing corners of the gate frame.
  8. Screw the diagonal support in place to transfer the weight of the gate to the hinge side and keep the gate from sagging.
  9. Screw the pickets to the diagonal gate support to provide more support strength.
  10. In addition, wide gates can be reinforced using an anti-sag kit consisting of two corner brackets, a steel cable, and a turnbuckle to tighten the cable as needed.

Watch this video to find out more.

Further Information

Print

Source: www.todayshomeowner.com

CATEGORIES